E-flite - Power 10 Brushless Outrunner Motor, 1100Kv

Power 10 Brushless Outrunner Motor, 1100Kv

Specs

Needed to Complete

40A ESC

6- to 10-cell Ni-MH/Ni-Cd or 2–3S Li-Po

10x5 to 12x6 electric props

Tech Notes

* Maximum Operating Temperature: 220 degrees Fahrenheit
* Adequate cooling is required for all motor operation at maximum current levels.
* Maximum Burst Current duration is 15 seconds. Adequate time between maximum burst intervals is required for proper cooling and to avoid overheating the motor.
* Maximum Burst Current rating is for 3D and limited motor run flights. Lack of proper throttle management may result in damage to the motor since excessive use of burst current may overheat the motor.

Examples of Airplane Setups:
Please see our web site for the most up-to-date information and airplane setup examples.

NOTE: All data measured at full throttle. Actual performance may vary depending on battery and flight conditions.
E-flite Brio 10

Motor: Power 10
ESC: E-flite 40A Brushless V2 (EFLA311B)
Prop: APC 12x6E (APC12060E)
Battery: Thunder Power PRO LITE 2100mAh 11.1V 3-Cell (THP21003SPL)
Flying Weight w/Battery: 2.1 lbs

Amps   Volts   Watts      Input Watts/Pound     RPM
37.2      9.6       357               170                 7800

Expect good speed and extreme vertical power for artistic aerobatics. Average duration is approximately 6-9 minutes depending on throttle management.

E-flite Ultimate 20-300 10e

Motor: Power 10
ESC: E-flite 40A Lite Pro SB Brushless (EFLA1040L)
Prop: APC 12x6E (APC12060E)
Battery: Thunder Power 2600mAh 11.1V 3S PRO LITE V2 Li-Po (THP26003SPL2)
Flying Weight w/Battery: 40.7 oz (2.5)

Amps     Volts     Watts       Input Watts/Pound      RPM
40.2        10.7      430                    172               8350

Expect ballistic power very strong vertical performance ideal for pulling out of hovers. Average duration is approximately 5-8 minutes depending on throttle management.